BLOWERS
AUTOLID REBUILD PARTS
List of Autolid Accessories
- Nylock Nut, 1/2-13 for wire forms
- Spring Holder and cap, Cover Return
- Shoulder Bolt, 1 1/4″ for Pivot Assembly
- Shoulder Bolt, 2- 1/4″ for Cover Return Spring
- Cover Return Spring ( 6 Located on Lid Top Casting)
- Spring Holder and cap, Cover Return
- Locknut 1-1/14 For Pivot Shaft Top
- Shim Top On Bearing Pivot Shaft
- Thrust Roller Bearing with Bearing Case
- Needle Roller Bearing (Pressed into Lid Top Casting for Pivot Shaft)
- Lid Top Casting with bearing AL122
- RMC Auto Lid, Air Bag
- Lid Hatch Cover Casting with Gasket Groove
- Jam Nut, 1/2-13 for wire forms
- Stainless Steel Wire Form
- Bearing Shaft 1-14 Threaded
- Female Bulkhead connector, 1/4NPT to 1/4 Tube
- 90 degree Elbow 1/4 x 1/4, yellow line to airbag
- Grade 8 Washer 1/2″ for Pivot Shaft Bottom
- Grade 8 Bolt 1/2-13×1″ for Pivot Shaft Bottom
- Lid Bottom Base Ring Assembly, bearing shaft and fittings
- Lid bottom base ring assembly, Betts with bearing shaft and fittings
- 3 Piece Pivot Assembly with Bushing and Hardware
- Cylinder assembly with internal lid close valve switch
- Nylock Nut, 3/8-16
- Rear Bolt For Air Cylinder, 3/8-16 x 2-1/4 HCS
- Wire Form Assembly Includes two Jam Nuts and Two Lock Nuts
- Spring Holder and cap assembly with spring and shoulder bolt
AUTOLID ACCESSORIES
List of Autolid Accessories
- Nylock Nut, 1/2-13 for wire forms
- Spring Holder and cap, Cover Return
- Shoulder Bolt, 1 1/4″ for Pivot Assembly
- Shoulder Bolt, 2- 1/4″ for Cover Return Spring
- Cover Return Spring ( 6 Located on Lid Top Casting)
- Spring Holder and cap, Cover Return
- Locknut 1-1/14 For Pivot Shaft Top
- Shim Top On Bearing Pivot Shaft
- Thrust Roller Bearing with Bearing Case
- Needle Roller Bearing (Pressed into Lid Top Casting for Pivot Shaft)
- Lid Top Casting with bearing AL122
- RMC Auto Lid, Air Bag
- Lid Hatch Cover Casting with Gasket Groove
- Jam Nut, 1/2-13 for wire forms
- Stainless Steel Wire Form
- Bearing Shaft 1-14 Threaded
- Female Bulkhead connector, 1/4NPT to 1/4 Tube
- 90 degree Elbow 1/4 x 1/4, yellow line to airbag
- Grade 8 Washer 1/2″ for Pivot Shaft Bottom
- Grade 8 Bolt 1/2-13×1″ for Pivot Shaft Bottom
- Lid Bottom Base Ring Assembly, bearing shaft and fittings
- Lid bottom base ring assembly, Betts with bearing shaft and fittings
- 3 Piece Pivot Assembly with Bushing and Hardware
- Cylinder assembly with internal lid close valve switch
- Nylock Nut, 3/8-16
- Rear Bolt For Air Cylinder, 3/8-16 x 2-1/4 HCS
- Wire Form Assembly Includes two Jam Nuts and Two Lock Nuts
- Spring Holder and cap assembly with spring and shoulder bolt